Easton X10 Shaft 12 pcs 900 / C3

The Easton X10 was developed specifically for long-distance recurve archery, with particular focus on 70-metre competition. Since its introduction at the 1996 Olympic Games in Atlanta, the X10 has become one of the most successful target shafts in international competition.

Its fully barrelled profile is widest in the centre and tapers towards both the point and the nock. This design improves aerodynamics, reduces sensitivity to release inconsistencies and helps maintain higher average arrow speed with less wind drift.

• Construction: high-strength carbon over a 7075 aluminium core
• Straightness: ±0.001 inch
• Weight tolerance: ±0.5 grain per matched dozen
• Available in a wide range of spine values

If required, we can cut the shaft to the selected length. Enter the required bare shaft length without nock or point in 1/4-inch increments or in centimetres. Leave the field empty if the shaft is not to be shortened. Small cutting tolerances of a few millimetres may occur.

If requested, the arrow or shaft can be cut to your desired length.

Please enter the desired arrow or shaft length in 1/4-inch increments (e.g. 28.75 inches) or in centimetres (e.g. 73.3 cm).

IMPORTANT: Measure and enter the length exactly as shown in the image.

If you do not want the arrow or shaft to be cut, simply leave the text field blank.

Please note that we cut arrows and shafts to your requested length as accurately as possible. However, deviations of a few millimetres may occur.