Beiter - Centralizer Monostabilisator
Product.Nr.: 1051027
Manufacturer: Beiter
EUR 93,09
incl. 19 % VAT
-
- delivery time 2 - 10 Tage
The Beiter Centralizer was - like all Beiter products - tested by world-class shooters
and has been used with much success since its introduction in 1996.
Four carbon tubes arranged in a square are supported by plastic blocks (tuners).
made of high-quality thermoplastic and elastomer held together and therefore
a novel stabilization concept.
It was already shown in the test phase that vibrations are increasingly absorbed,
the shooter can stand better on target and the bow rocks less.
The system can be individually adapted not only through the number and distance of the so-called tuners,
but also through the variety of combinations of lengths and designs - with end cap or weight adapter.
The tuners are set at the factory so that there is no resonance;
However, they are individually adjustable to enable individual adjustment.
The Beiter Centralizer monostabilizer is available in the following lengths:
- 26”, 28”, 30”, 33”, 35”, 37”, 41”, 45”, 49”, 54”
- Choice with an end cap or with a weight adapter,
- As well as depending on the length with a number of 2, 3, 4 or 5 tuners (intermediate blocks).
The following lengths and tuner combinations are available:
| Combination options | |
|---|---|
| Bar length in inches | Number of possible tuners |
| 26 inches | 2 tuners |
| 28 inches | 2 or 3 tuners |
| 30 inches | 2 or 3 tuners |
| 33 inches | 2, 3 or 4 tuners |
| 35 inches | 2, 3 or 4 tuners |
| 37 inches | 2, 3 or 4 tuners |
| 41 inches | 2, 3 or 4 tuners |
| 45 inches | 2, 3 or 4 tuners |
| 49 inches | 4 or 5 tuners |
| 54 inches | 4 or 5 tuners |
The Centralizer monostabilizer has a 5/16 inch thread for attachment.
The thread is available in two lengths.
If you would like to use a Beiter V-Bar (spider), choose
a thread length of 28 mm.
Would you like the Stabi without a V-Bar or with a different V-Bar than the Beiter V-Bar
If you want to use it, choose the 16 mm long thread.
The optional weight adapter for attaching dampers and weights
has a 1/4 inch thread.
All Centralizers are delivered with fixed tuner spacing.
It is possible to move the individual tuners,
to install or remove one or more tuners.
However, it is advisable to mark the original positions,
if the factory settings should be restored.
If this is no longer comprehensible,
then follow this link to get information about the original settings:
Beiter_Centralizer_Abstaende.pdf (0.01 MB)
Manufacturer identification
Manufacturer identification
Name: WERNER BEITER GMBH & CO. KGE-Mail adress: info@wernerbeiter.com
Streetaddress: Daimlerstraße 18
ZIP Code: 78083
City: Dauchingen
Country: DE
Phone: +49 7720 85 68 60